Instructions for Use

Last updated: 2026-07-18

NO SPLASHIN' — a cover for pressure-washing trash bins.

Intended use

The NO SPLASHIN' cover is a tool for pressure-washing trash bins. It helps reduce spray and splashback from the bin, but it does not guarantee that all water will stay inside or that the user will not get wet. The product is intended solely for this purpose.

Sizes

Size	Bin	Approx. bin dimensions (W × D × H)
S	80-litre	45 × 55 × 94 cm
M	120-litre	48 × 54 × 95 cm

⚠ Safety warnings

Sharp corner edges. Despite edge protection, aluminium corners may be sharp. Wear suitable protective gloves when handling, fitting, cleaning, or inspecting the cover. Check the edges, rubber edge protection, and handle before every use. Do not use a damaged product or one with loose or missing edge protection.
The product is not a toy. Keep it out of the reach of children and do not leave it unattended where children can access it.
A high-pressure jet can cause serious injury. Never point the jet at people, animals, or at the cover from below. Follow your pressure washer manufacturer's instructions.
Always hold the cover steady with one hand while washing so it cannot shift.
The cover does not keep 100% of water inside the bin and does not guarantee the user stays dry.
Do not stand or sit on the cover, and do not use it as a bin lid during transport or emptying.

Use in 3 steps

Attach. Open the bin and place the NO SPLASHIN' cover on the bin opening.
Wash. Insert your pressure-washer wand through the slit and wash the interior from every angle. Hold the cover with one hand. The cover helps reduce water and grime splashing out of the bin.
Detach & rinse. Remove the cover and rinse it off briefly. Still wear suitable clothing and footwear while using it.

Care and storage

Rinse the cover with clean water after each use and let it dry. Store it upright or flat, protected from frost and direct sunlight. Do not use aggressive solvents.

Keep these instructions for future reference and pass them on with the product.